media
stray_light_fogging
slf
Trendsetter_NEWS
For integrating media such as the T96-3 plate, special care must be taken to avoid image
artifacts. Stray light from the light valve will expose the plate in a very short amount
of time. Specifically, two changes have been made:
if the job is cancelled any time after the focus learn starts, the plate is considered a
reject. This is because a second focus learn will cause a dark line to appear on the plate.
The error message 16072: "Plate rejected because it was cancelled too late in the imaging
sequence" will indicate this condition.
retraces cause image artifacts, so are not allowed. Currently, imaging will be completed,
then the machine will suspend with a warning message indicating that retraces occurred. This
lets the operator know that the plate is probably not usable.
For such a media, the new parameter media slf (stray_light_fogging) should be set to 1 to put
into place these extra checks.
uint8